Why we’re swapping out old bathroom heaters for IP65 Infrared
Let’s be honest: those old halogen lamp heaters are a pain. You’ve probably dealt with them—the ones that flicker or just give up the ghost because a bit of steam got into the wrong place. In a bathroom, water and electricity are a bad mix, and those old lamps just aren’t built for the humidity. That’s why we’ve started moving toward IP65-rated infrared heaters. They just make more sense. What’s the deal with “IP65”? Basically, it means the unit is sealed tight. No dust gets in, and water splashes can’t sneak through to the guts of the machine. Think about that thick steam after a hot shower. In a cheap heater, that moisture creeps into the wiring, and suddenly you get that nasty “burnt electrical” smell. With an IP65 rating, we’ve sealed the elements and connections so that doesn’t happen. It stays dry inside, even when it’s a sauna outside. Warm air vs. Warm skin Here is the real difference: traditional heaters try to warm up the air. But bathrooms are usually drafty. The second you open the door to leave, all that warmth vanishes. Infrared is different. It doesn’t waste time with the air; it sends heat directly to your skin or the floor. It’s a physical sensation of warmth that hits you immediately. We use quartz tubes to keep that heat concentrated, so you aren’t standing around waiting to feel it. A few things to keep in mind You can put these in the ceiling or on the wall, butplacement is everything. If you mount them too low, you’re going to overheat the wall or the person standing under it. Too high, and you lose that cozy feeling. You have to find that sweet spot. Also, a heads-up on the power. These things pull a lot of juice. If you’re planning to run a few of these panels alongside a big water heater, a standard 15A circuit probably won’t cut it. You’ll want to check your breakers and wiring first so you don’t keep tripping the power. At the end of the day, we build these to take a beating from the humidity. As long as your electrical setup can handle the wattage, they’ll outlast those old open-lamp heaters by a mile.